Heavy Duty Die Cut Vinyl Sticker – 10″x14″ – perfect for your car’s rear window!

Application Directions:

1) Lay decal FACE UP on a smooth hard surface. Squeegee
the surface to insure good contact between the pre-mask and the vinyl beneath
it.

2) Lay decal flat, FACE DOWN. Slowly remove backing paper
from the pre-mask, pulling straight back and flat (not at an angle).

3) Apply pressure-sensitive vinyl to prepared (cleaned
and dried) surface, then squeegee pre-mask surface using overlapping
strokes.

4) Pull pre-masking away at an angle using a continuous
motion. If bubbles occur in the letters, simply prick with a needle and smooth.
Do not use a knife or razor.